This compact flash adapter fits directly onto a standard 40 pin IDE header without any cable. Due to its height in may not fit into every chassis. Since the 40 pin IDE bus does not supply power to the adapter a floppy type connector has been provided to power the CompactFlash Card.

This compact flash adapter requires a generic 40 pin IDE cable. It has a jumper to allow operation as master or slave drive. The power connector is a standard hard disk style connector.

This compact flash adapter matches the footprint and mounting pattern of a 2.5" disk drive. However, it is not a 100% mechanical replacement for a 2.5" disk drive. It requires a 44 pin cable which also supplies power to the drive. No other power connectors are required.

This compact flash adapter fits directly onto a standard 40 pin IDE header without any cable. It has a straight 40 pin header. This adapter mounts parallel to the system board. Since the 40 pin IDE bus does not supply power to the adapter a floppy type connector has been provided to power the CompactFlash Card.